Steel Structure Power Plant
If the player does not load, open the video on YouTube
This video introduces Steel Structure Power Plant, a JDCC solution in the Warehouses And Workshops category. The video runs for approximately 0 min 44 s. It helps project teams review the product before requesting technical information or pricing.
The video shows the steel frames, purlins, roof, wall cladding and overall layout of an industrial warehouse or workshop.
Key features: Depending on the size of the steam generator, between 20 and 40 working platforms are required. For their construction, the entire range of available rolled sections is used. Rolled sections are used almost everywhere for both the supports and main and secondary beams of the p...
Product overview: Depending on the size of the steam generator, between 20 and 40 working platforms are required. For their construction, the entire range of available rolled sections is used. Rolled sections are used almost everywhere for both the supports and main and secondary beams of the platforms. For the storage of the coal, a bunker is required. While the bunker structure normally consists of heavy I-sections or box sections, the house structure and working platforms are normally made of rolled sections. In the air heater house, which is attached to the boiler house, fresh air is pre-heated by the flue gas stream. Again, rolled sections are used for the house structure and working platforms. Then there is also the power house and dependent buildings that are constructed mainly with rolled sections. In addition to using rolled I-sections as bending beams and supports in platforms, façades and.
Review the video and compare Steel Structure Power Plant with the requirements of your project. JDCC can prepare a technical proposal covering spans, loads, materials, finishes, supply scope and fabrication schedule.